Panasonic PCV1 User Manual

MODEL:  Miniature Camera

PCF1, PCV1

 (1) Housing
 (1) Weather hood
 (1) Cover plate

      (1) Cover plate gasket
      (1) Allen wrench security head tool
      (2) Stainless steel 6-32x1/2" captive Security head screws

 (1) Camera mount bracket
 (1) Camera bracket arm
 (1) Bottom mount bracket with PC Board
 (1) Top mount bracket with camera and lens
 (2) 4-40 x 1/4" screws

      (2) Star washers

 (4) 2-56 x 3/16" screws

1. Remove the cover plate by loosening the 2 security head
    screws with the security tool.
2. If mounting the unit to a wall:
    A. Remove the 2 Phillips head screws that secure the
         bottom mount bracket and PC Board to the housing,
         then remove the bracket.  Repeat for the top mount
         bracket and camera.
    B.  Place the housing face down on a flat surface and use
         a hammer to remove the knockout located at the
         center of the back of the housing.
    C. Use the 2 mounting holes and the appropriate
         hardware (not included)to secure the housing to the
         wall.

3. If mounting the unit on a pedestal:
    NOTE:  3/4" conduit with a threaded end is required for this
                method of installation.
    A. Install the conduit in the desired location; run the
         wiring through the conduit.
    B. Place the PFC1/PCV1 housing onto the conduit, feed
        the wires through the bottom hole and thread the
        housing onto the conduit until tight.

N

 

NOTE:  Apply silicone sealant to the conduit threads and

                the hole plug to ensure a water tight seal.

4. Make the necessary connections to the PC Board and
    reattach the bottom bracket to the housing.

Top mount bracket and camera

Bottom mount bracket and PC Board

!

5. Hand place the top bracket and camera into the unit.
    Check the angle of the camera, remove the bracket/
    camera and make any necessary adjustments.  Once
    you have achieved the desired camera angle, reattach
    the top bracket and camera to the housing.
6. Fine focusing (see diagram below):
    Fixed Lens:  Manually rotate the lens until a clear picture is
                         achieved.
    Vari-Focal Lens:  First, adjust the Magnification Lock Screw
                                 to the desired magnification (telephoto
                                 to wide angle).  Tighten the Lock Screw.
                                 Next, adjust the Focus Lock Screw until a
                                 clear picture is achieved.  Tighten the
                                 Lock Screw.

Manual focus

Focus Lock Screw

Magnification
Lock Screw

Manufactured by:

for

Before attempting to connect or operate this product, please read these instructions completely.

81-IN3046-9922

DESCRIPTION:  Outdoor Pedestal Mount Housing,
                          Color Camera