Panasonic PCF2 User Manual

DOME REPLACEMENT
1. Rotate the liner inside the dome, so that when the dome is

secured to the base, the camera lens is in the center of the
viewing slot of the liner.

    NOTE:  It may be helpful to install the dome without the liner
                the first time.  This way you can visually determine
                which direction the lens is pointing and adjust the liner
                opening accordingly.
2. Align and insert the three tabs of the dome with the three tab

slots on the dome base.  Rotate the dome clockwise until the
dome locks into place.

CAMERA ADJUSTMENT
1. Clip the tabs of the template onto the swivel plate so that the

template is attached to the swivel plate.

2. Loosen the two 4-40 Phillips head screws, adjust the camera to

the desired position, and tighten the screws.

     Note:  Adjust camera lens as close as possible to the outline of
               the bottom of the template.

Camera swivel plate

Camera Adjustment
 Arm

Camera Mount with
Camera and PC Board

Loosen screws to adjust  camera

Tab

Tab

Place the lens as close to

this edge as possible

Camera Adjustment Template

Liner

Dome

Tabs

Base

3. Fine focusing (see diagram below):
    Fixed Lens:  Manually rotate the lens until a clear picture is
                         achieved.
    Vari-Focal Lens:  First, adjust the Magnification Lock Screw
                                 to the desired magnification (telephoto
                                 to wide angle).  Tighten the Lock Screw.
                                 Next, adjust the Focus Lock Screw until a
                                 clear picture is achieved.  Tighten the
                                 Lock Screw.

Manual focus

Focus Lock Screw

Magnification
Lock Screw

Video 
BNC Connectors

Power Connections
NOTE:  Splice wiring according to 
standard electrical guidlines.  
Positive and Negative connections are 
interchangeable with this PC Board.