Panasonic WV-CP500 User Manual

5

The description below explains how to operate the setup menu basically. 
The operations in the setup menu are performed with the operation buttons after calling up the setup menu on the connected 
video monitor. Refer to the installation guide for further information about the operation buttons. 
The operations in the setup menu can also be performed through the system controller (option). 
     

Hold down the setting button for approx. 2 seconds to call 
up the top screen of the setup menu. 
     

Press the up or down button to move the cursor to "END". 

Press  the  right  button  to  move  the  cursor  to  "SETUP",  and 
press  the  setting  button  to  change  the  setup  mode  from 
"DISABLE" to "ENABLE". 
     

The setup mode changes to "ENABLE", and the setup menu 
becomes ready to be set. 
     

Move the cursor to the item to be set, and press the setting 
button. 
     

The  selected  setup  screen  in  the  setup  menu  appears  on 
the screen. 

 •  If the top screen of the setup menu is called up with the

operation  buttons  while  a  camera  image  is  displayed, 
the  setup  mode  is  always  "DISABLE"  to  prevent  opera-
tion errors. 

    To configure the settings in the setup menu, change the 

setup mode to "ENABLE". 

 •  The cursor is a reversely highlighted part.

     

Perform the settings for each item. 
 •  Selection of setting item:
    Press the up or down button to move the cursor. 
 •  Change of settings:
    Press the right or left button. 
 •  Display of advanced setup screen:
    Press the setting button when "

O" is attached to the tar-

get setting item. 

 •  Return to previous setup screen:
    Move the cursor to "RET" and press the setting button. 
 •  Return to the top screen:
    Move the cursor to "TOP" and press the setting button. 

To  return  to  the  camera  image  screen,  move  the  cursor  to 
"END" and press the setting button.