Panasonic WV-NW474SE User Manual

-29-

■ Network Setup (NETWORK

Set up network parameters when connecting the
10/100BASE jack with a network.

• Access the setup menu from the PC to use the

DHCP or DNS server, because these settings are
not included in this window.

• Ask your system administrator or ISP (Internet

Service Provider) about available IP address, subnet
mask, and gateway, prior to setup.

• The assigned address should be a global type when

connecting via the Internet. Ask your ISP whether it
is.

1. Move the cursor to NETWORK SETUP in the SETUP

menu window and press [SET]. The NETWORK
SETUP menu opens. 

The factory default settings are as follows.

IP ADDRESS: 192.168.0.10
NETMASK: 255.255.255.0
GATEWAY: 192.168.0.1
HTTP Port Number: 80
DHCP: OFF

2. Move the cursor to the line you wish to edit, and

press [SET].
Parameters become editable.

3. Select a digit using [Left] or [Right].
4. Select a number in the digit using [Up] or [Down].
5. Repeat steps 2, 3 and 4 above appropriately until all

parameters are set.

6. Move the cursor to END and press [SET] to close

the setup menu and store new settings, or select
RET to go back to the SETUP menu.

Note: The port number assigned to the camera is

exclusive, and any other usage is not allowed.