Panasonic WV-NS950 User Manual

 

The firmware upload is performed through the browser GUI. 

(1) Open the Setup/Maintenance menu 

(2) Open the Upgrade tab menu

(3) Click "Browse" and navigate to the correct firmware 

(e.g. "np244_xxxxx.img") and select the firmware.

(4) Select whether you wish to initialize the setup data 

during the upgrade process by the radio button.

(5) Click "Upgrade". Confirmation message will be 

displayed. Click "OK" to start loading the firmware. 
When "Do not reset the settings after completing the 
upgrade. " was selected, the confirmation message  
will not be displayed.

(6) "Upload in progress" is displayed. It takes 2 to 4 

minutes depending on the camera model. When com-
pleted, the browser GUI automatically displays live 
image.

(7) After the upgrade, check the updated firmware version on the "Setup menu/Maintenance/Upgrade tab".

Note: The following network settings will not be initialized during the firmware upgrade procedure.
On/Off for DHCP, IP address, subnet mask, default, gateway, HTTP port, line speed, bandwidth control (bit rate), time & date

Caution ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
• When upgrading, connect the PC in the same subnet as the camera. 
• Do not turn off the power during the upgrade.
• Do not operate the browser GUI during the upgrade.
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

This procedure is optional. Setup data can be restored as follows. This can also be used to copy setup data from another camera 
(same model). Prior to loading the setup data, change the file name from "system.cfg" to the file name respective to the camera 
model as shown below (except for WV-NP1000 series).

WV-NP240 series: np244setup.dat
WV-NS202 series: ns202setup.dat
WV-NS202A series: ns202asetup.dat
WV-NF284 series: nf284setup.dat
WV-NW484 series: nw484setup.dat
WV-NS950/NW960 series: ns950setup.dat
WV-NF302/NP304 series: nf302setup.dat