Panasonic WV-CW864 User Manual

26

■

• Move the cursor to LOCAL/REMOTE, and select LOCAL or

REMOTE by moving the joystick to the right or left.
The factory default setting is LOCAL.

The REMOTE mode does not work when the WV-RM70,

WV-CU360, WV-CU161, WJ-FS616 or WV-CU550 series is
connected. Make sure that LOCAL mode is selected in this
case.

■

●

Up to 8 unwanted zones can be masked on the monitor screen.

1. Move the cursor to PRIVACY ZONE and select ON (ENB) or OFF

(ENB) by moving the joystick to the right or left. Press the CAM
(SET) key to display the ZONE NUMBER setting menu.
The factory default setting is OFF (ENB).

Preset privacy zones are veiled on the monitor screen.

The veiling function does not work.

If ON(DIS) or OFF(DIS) appears for PRIVACY ZONE, the

steps from 2 onward are not applicable. Select OFF for PASS-
WORD LOCK to take the following steps.

2. Select a zone number by moving the joystick to the right or left,

and press the CAM (SET) key.

• A zone number followed by * (asterisk) indicates that the zone

has already been registered.

• When a zone number having no * is selected, the picture is

zoomed out fully.

• When a registered zone number is selected, the camera

moves to the preset position. Note that if you move PAN/TILT,
ZOOM/FOCUS or ZONE SCALE in that position, the regis-
tered zone number having “*” is cancelled.

• The zone frame appears in the center of the screen if 3 or

fewer mask areas exist in that picture and if the zone number
is not registered yet.

• The privacy zone may appear on the monitor screen depend-

ing on the direction of the camera.

• The privacy zone function will not work at start-up immediate-

ly after turning the power on.

Special 1 menu

ZONE NUMBER setting menu

Setup menu

→

→

ZONE SCALE   ••••|•••• 
SET DEL      –       +
RET

ZONE setting menu

→

→

ZONE SCALE   ••••|•••• 
SET DEL      –       +
RET

ZONE setting menu