Panasonic WV-SW458E User Manual

13

This product is designed to be installed 
under eaves.
Install the product under eaves to avoid direct 
sunlight.

Installing place
Contact your dealer for assistance if you are 
unsure of an appropriate place in your particu-
lar environment.
 •  Make  sure  that  the  installation  area  is

strong enough to hold this product, such 
as a concrete ceiling. 

 •  Install the camera in the foundation area of

the architecture or where sufficient strength 
is assured.

 •  If a ceiling board such as plaster board is

too weak to support the total weight, the 
area shall be sufficiently reinforced.

Do not place this product in the following 
places:
 •  Locations where a chemical agent is used

such as a swimming pool

 •  Locations subject to moisture or oil smoke

such as a kitchen

 •  Locations that have a specific environment

that is subject to an inflammable atmo-
sphere or solvents

 •  Locations  where  a  radiation,  an  X-ray,  a

strong radio wave or a strong magnetic 
field is generated

 •  Locations  where  corrosive  gas  is  pro-

duced, locations where it may be damaged 
by briny air such as seashores

 •  Locations  where  the  temperature  is  not

within the specified range (page 37) 

 •  Locations subject to vibrations that exceed

the railway specifications (EN50155)

Do not install this product in a humid or 
dust-laden environment.
Otherwise, lifetime of the internal parts may be 
shortened.

Shielded (STP) LAN cables must be used 
with this unit to ensure compliance with 
EMC standards. *
* E models only

Design and engineer the power supply 
system to turn on/off the power of this 
product. 
The product has no power switch. When 
installing the product, use a power supply 
device equipped with the ON-OFF switch for 
servicing. 

About the network connection
When connecting to a network using the net-
work cable of this product, observe the follow-
ing.
 •  When  wiring  for  the  network,  design  and

engineer not to be affected by thunder.

Screw tightening
 •  The  screws  and  bolts  must  be  tightened

with an appropriate tightening torque 
according to the material and strength of 
the installation area.

 •  Do  not  use  an  impact  driver.  Use  of  an

impact driver may damage the screws or 
cause tightening excessively.

 •  Tighten screws at a right angle to the sur-

face. After tightening screws, perform 
checks to ensure that the tightening is suf-
ficient enough so that there is no move-
ment or looseness.