Panasonic BL-C121 Leaflet
Important Information
Network Camera
Model No.
BL-C101
(Wired Type)
BL-C121
(Wireless/Wired Type)
© Panasonic Communications Co., Ltd. 2008
PNQX1565ZA KK0908CM0
PNQX1565ZA KK0908CM0
How to Use the Documentation
This manual is written for both the BL-C101 (Wired Type) and BL-C121
(Wireless/Wired Type). Available features and operations vary slightly
depending on the model. You can confirm the model no. of your camera by
checking the model no. printed on the front of the camera.
Model number suffix “A” is omitted from the following model numbers
shown in this document, unless necessary. BL-C101A, BL-C121A
All documentation can be found on the included CD-ROM.
(Wireless/Wired Type). Available features and operations vary slightly
depending on the model. You can confirm the model no. of your camera by
checking the model no. printed on the front of the camera.
Model number suffix “A” is omitted from the following model numbers
shown in this document, unless necessary. BL-C101A, BL-C121A
All documentation can be found on the included CD-ROM.
• Important Information (PDF format; printed version also included)
This document. Provides general information and safety instructions for
using the camera.
using the camera.
• Installation Guide (PDF format; printed version also included)
Describes how to physically connect the camera to the power supply
and network, as well how to mount or place the camera for regular use.
and network, as well how to mount or place the camera for regular use.
• Setup Guide (PDF format; printed version also included)
Describes how to set up the camera so that it can be accessed using a
PC.
PC.
• Operating Instructions (HTML format)
Explains how to operate, program, and maintain the camera.
• Troubleshooting Guide (HTML format)
Provides solutions for problems you may have when using the camera.
Abbreviations
• The Network Camera is referred to as “the camera” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
IMPORTANT SAFETY INSTRUCTIONS
When using this unit, basic safety precautions should always be followed
to reduce the risk of fire, electric shock, or personal injury.
to reduce the risk of fire, electric shock, or personal injury.
1.
Read and understand all instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Attach the Safety Wire to the camera to prevent it from dropping.
6.
To clean the camera lens, first remove any dust or dirt from the lens,
then wipe the lens with a cotton bud.
then wipe the lens with a cotton bud.
7.
Do not block any ventilation openings. Install in accordance with
instructions.
instructions.
8.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
stoves, or other devices (including amplifiers) that produce heat.
9.
Protect the AC adaptor cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where
they exit from the unit.
particularly at plugs, convenience receptacles, and the point where
they exit from the unit.
10. The AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
11. Only use attachments/accessories (such as stands) specified by the
manufacturer.
12. Do not touch the unit, the LAN cable, AC adaptor, or AC adaptor cord
during lightning storms.
13. Unplug the unit when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
14. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as when the AC
adaptor is damaged, the unit does not operate normally, or after the
unit has been dropped.
adaptor is damaged, the unit does not operate normally, or after the
unit has been dropped.
15. The camera is intended for indoor use only. Prolonged exposure to
direct sunlight or halogen light may damage the image sensor.
16. For BL-C121: Please check local regulations as outdoor use of the
wireless feature is restricted in some countries/areas.
17. Unplug this unit from power outlets if it emits smoke, an abnormal
smell or makes unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
SAVE THESE INSTRUCTIONS
FCC and Other Information
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
For BL-C121: Operating near 2.4 GHz electrical appliances may cause
interference. Move away from the electrical appliances.
Environment:
Do not install the camera where the temperature is less than +5 °C (+41 °F)
or greater than +40 °C (+104 °F). Allow 10 cm (4 inches) clearance around
the unit for proper ventilation. Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive
powder.
When you leave the unit unused for a long period of time, disconnect the
AC adaptor from the outlet.
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this device.
FCC RF Exposure Warning:
For BL-C121: To comply with FCC RF exposure requirements in
uncontrolled environment:
– This equipment must be installed and operated in accordance with
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
For BL-C121: Operating near 2.4 GHz electrical appliances may cause
interference. Move away from the electrical appliances.
Environment:
Do not install the camera where the temperature is less than +5 °C (+41 °F)
or greater than +40 °C (+104 °F). Allow 10 cm (4 inches) clearance around
the unit for proper ventilation. Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive
powder.
When you leave the unit unused for a long period of time, disconnect the
AC adaptor from the outlet.
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this device.
FCC RF Exposure Warning:
For BL-C121: To comply with FCC RF exposure requirements in
uncontrolled environment:
– This equipment must be installed and operated in accordance with
provided instructions and a minimum 20 cm (8 inches) spacing must be
provided between antenna and all person's body (excluding extremities
of hands, wrist and feet) during wireless modes of operation.
provided between antenna and all person's body (excluding extremities
of hands, wrist and feet) during wireless modes of operation.
– This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.
MEDICAL:
For BL-C121: Consult the manufacturer of any personal medical devices,
such as pacemakers, to determine if they are adequately shielded from
external RF (radio frequency) energy. (The unit operates in the frequency
range of 2.412 GHz to 2.462 GHz, and the power output level is 0.1 watts.)
Do not use the unit in health care facilities if any regulations posted in the
area instruct you not to do so. Hospitals or health care facilities may be
using equipment that could be sensitive to external RF (radio frequency)
energy.
For BL-C121: Consult the manufacturer of any personal medical devices,
such as pacemakers, to determine if they are adequately shielded from
external RF (radio frequency) energy. (The unit operates in the frequency
range of 2.412 GHz to 2.462 GHz, and the power output level is 0.1 watts.)
Do not use the unit in health care facilities if any regulations posted in the
area instruct you not to do so. Hospitals or health care facilities may be
using equipment that could be sensitive to external RF (radio frequency)
energy.
CR Coin Cell Lithium Battery Information:
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate
No responsibility will be taken by our company with respect to
consequences resulting from the use, damage or both of the
camera.
consequences resulting from the use, damage or both of the
camera.
Please read this document before using the product, and save this document for future
reference.
Panasonic Network Camera Website:
http://panasonic.net/pcc/products/netwkcam/
reference.
Panasonic Network Camera Website:
http://panasonic.net/pcc/products/netwkcam/
Indoor Use Only