Pelco EH5700 User Manual

4

Pelco Manual C1432M-C (11/99)

Window wiper kits in the WW57 Series are for installation in the EH5700 Series and
EH5700L Legacy

®

 Series environmental enclosures.

WW5723-1

Window wiper kit for EH5723/EH5723L, 120 VAC, 15 watts

WW5723-2

Window wiper kit for EH5723/EH5723L, 24 VAC, 15 watts (CE)

WW5723-3

Window wiper kit for EH5723/EH5723L, 230 VAC, 15 watts (CE)

WW5729-1

Window wiper kit for EH5729/EH5729L, 120 VAC, 15 watts

WW5729-2

Window wiper kit for EH5729/EH5729L, 24 VAC, 15 watts (CE)

WW5729-3

Window wiper kit for EH5729/EH5729L, 230 VAC, 15 watts (CE)

Window wiper kits in the WW57 Series are designed to operate with an AC voltage to turn
on the wiper. However, the kits must be modified to use +5 to +10 VDC to turn on the wiper
when the kits are used with Pelco’s receivers.

If you are going to use a Pelco receiver, proceed to the 

Window Wiper Kit Modification

 sec-

tion.

If you are going to use equipment that provides AC power to control the wiper, proceed to
the 

Window Wiper Kit Installation

 section.

Modify your wiper kit if it is to be operated from any of the following Pelco receivers:

CX9000 Series
WX8000 Series
LRD41 Series
ERD97P21-U with the ERD97P-AUX option board

This modification only changes the voltage that is required to turn on the wiper. The wiper
motor still requires AC voltage (refer to Figure 1).

To modify a kit:

1.

Remove the circuit board cover from the wiper motor/control assembly and remove the
circuit board (PCB9000275 Rev. E). Refer to Figure 10 for parts locations.

Refer to Figure 2 for steps 2-5.

AUX

OUTPUT

RECEIVER      ENCLOSURE

+5 TO +10 VDC

WIPER

ON/OFF

CIRCUIT

LENS COMMON

AC HI

WIPER

MOTOR

AC NT

Figure 1.  Wiper Modification