Pelco C3426M-D (3/08) 3 User Manual
C3426M-D (3/08)
11
6. Connect the power wires, refer to Table D.
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one
side of the transformer to the red wire on all units; connect the other side of the transformer to the
black wire on all units.
side of the transformer to the red wire on all units; connect the other side of the transformer to the
black wire on all units.
NOTE: Failure to connect all AC powered units in the same way will cause the cameras to be out of
phase with each other, which and may produce a vertical roll when switching between cameras.
phase with each other, which and may produce a vertical roll when switching between cameras.
7. Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to
position the conduit plug opposite the notch on the side of the cover. Use the two 8-32 x 0.375-inch
Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.
Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.
Figure 3. 4S Electrical Box Installation
Table D. Power Input: 4S Electrical Box Installation
Voltage
Red Wire
Black Wire
12 VDC
+
Ground
24 VAC
~
~
8-32 X 0.75-INCH
PHILLIPS FLAT
HEAD SCREWS
(SUPPLIED)
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
COVER
BACK BOX
8-32 X 0.375-INCH
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED WITH
ICS110-AP)
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED WITH
ICS110-AP)
CEILING/
WALL
WALL
4S STANDARD
ELECTRICAL BOX
ELECTRICAL BOX
ADAPTER PLATE
(ICS110-AP)
(ICS110-AP)