ZyXEL Communications 3.1 User Manual
Chapter 13 HTTP Redirect
ZyWALL (ZLD) CLI Reference Guide
124
13.2 HTTP Redirect Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
are discussed with the corresponding commands.
The following table describes the commands available for HTTP redirection.
You must use the
configure terminal
command to enter the configuration mode before you can use these
commands.
Table 61
Input Values for HTTP Redirect Commands
LABEL
DESCRIPTION
description
The name to identify the rule. You may use 1-31 alphanumeric characters,
underscores(
underscores(
_
), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
interface_name
The name of the interface.
Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N,
where N equals the highest numbered Ethernet interface for your ZyWALL
model.
where N equals the highest numbered Ethernet interface for your ZyWALL
model.
The ZyWALL USG 200 and lower models use a name such as wan1, wan2,
opt, lan1, ext-wlan, or dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number
of the virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4
of the virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge
interfaces your ZyWALL model supports.
interfaces your ZyWALL model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge
interface, y = 1 - 4
interface, y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of
PPPoE/PPTP interfaces your ZyWALL model supports.
PPPoE/PPTP interfaces your ZyWALL model supports.
Table 62
Command Summary: HTTP Redirect
COMMAND
DESCRIPTION
ip http-redirect description interface interface_name
redirect-to w.x.y.z <1..65535>
Sets a HTTP redirect rule.
ip http-redirect description interface interface_name
redirect-to w.x.y.z <1..65535> deactivate
Disables a HTTP redirect rule.
ip http-redirect activate description
Enables a rule with the specified rule name.
ip http-redirect deactivate description
Disables a rule with the specified rule name.
no ip http-redirect description
Removes a rule with the specified rule name.
ip http-redirect flush
Clears all HTTP redirect rules.
show ip http-redirect [description]
Displays HTTP redirect settings.