American Dynamics 8200-2646-02 B0 User Manual

 

 

 

Please follow the instructions and the diagram below to set up the system. 

If the system software of the IP camera needs to be upgraded, please take the following steps to 

safely process it. 

 

1.   Format an SD card using the FAT format. 

2.   Create a directory named LANCAM in the SD card if it does not exist. 

3.   Copy the file of UPDATE.BIN to the LANCAM-directory. 

4.   If the IP camera is running, please power it off first. 

5.   Insert the SD CARD into the IP camera. 

6.   Remove the Ethernet cable from the RJ-45 port and then power on the IP camera. 

7.   In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on 

a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical 

support while ignoring the following steps. 

8.   DO NOT power off the IP camera while this update process is running until the message 

"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to 

appear. 

9.   If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET 

PLEASE", please write down the error messages shown on the screen and inform your 

technical support, while ignoring the following steps. 

10. Power off the IP camera when this update process is finished, then remove the SD card from 

the IP camera. 

11. Reconnect the Ethernet cable to the RJ-45 port as necessary. 

12. Power ON the IP camera and it will work normally if the entire update procedure goes correctly. 

13. Verify the version of the system software.