Bosch LTC 9365/00 User Manual
EN | 8
LTC 9365 Series | Instruction Manual | Installation
Figure 2 Housing Bottom
4. Remove the camera bracket by loosening the
two (2) 1/4in. bolts on either side of the bracket.
The nuts are held in place by the bracket,
allowing for self-tightening when they are
reinstalled.
The nuts are held in place by the bracket,
allowing for self-tightening when they are
reinstalled.
5. Remove one of the three knockouts on the
bottom of the housing (see Figure 2). This will
allow electrical and video cables to pass through.
allow electrical and video cables to pass through.
6. Secure the housing using the previously marked
mounting holes (hardware not included).
NOTE: If, in the course of this installation, you have
detached the housing top from the housing bottom, be
sure the top is reattached before securing the bottom
in the desired location.
detached the housing top from the housing bottom, be
sure the top is reattached before securing the bottom
in the desired location.
7. Install the camera on the camera bracket using
the 1/4-20 bolt provided. The position of the
camera bracket is adjustable, depending on the
camera size and the viewing angle. You may
install the bracket for either top or bottom
mount (see Figure 3). Do not completely tighten
the camera bracket at this time.
camera bracket is adjustable, depending on the
camera size and the viewing angle. You may
install the bracket for either top or bottom
mount (see Figure 3). Do not completely tighten
the camera bracket at this time.
NOTE: When installing the LTC 0300 & LTC 0400
Series cameras using the Top Mount Position, the
camera must be inverted and the mounting foot must
be relocated to the top of the camera by removing two
small screws.
Series cameras using the Top Mount Position, the
camera must be inverted and the mounting foot must
be relocated to the top of the camera by removing two
small screws.
Figure 3 Installing the Camera - Top and Bottom
Mounting Views
8. Make all the necessary electrical connections to
the camera.
9. Make final adjustments to the camera angle and
tighten the camera bracket.
10. Close the lower portion of the housing. The
housing top will snap to the housing bottom
and hold. This will allow you to tighten the two
(2) 10-32 security screws without having to hold
the housing in place (see Figure 4).
and hold. This will allow you to tighten the two
(2) 10-32 security screws without having to hold
the housing in place (see Figure 4).
Figure 4 Tightening the Security Screws
© 2004 Bosch Security Systems GmbH
3935 890 37712 04-30 | Updated July 23, 2004 | Data subject to change without notice.
Bosch Security Systems, Inc.
850 Greenfield Road
Lancaster, PA 17601 USA
Tel: 800-326-3270
Fax: 1-717-735-6560
www.boschsecuritysystems.com
850 Greenfield Road
Lancaster, PA 17601 USA
Tel: 800-326-3270
Fax: 1-717-735-6560
www.boschsecuritysystems.com
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven
The Netherlands
Tele +31 40 27 80000
P.O. Box 80002
5600 JB Eindhoven
The Netherlands
Tele +31 40 27 80000
Bosch Security Systems Pte Ltd.
38C Jalan Pemimpin
Singapore 577180
Republic of Singapore
Tel: 65 (6) 319 3486
38C Jalan Pemimpin
Singapore 577180
Republic of Singapore
Tel: 65 (6) 319 3486
Knockouts
Top Mount
Bottom Mount
Right Angle
BNC Connector
BNC Connector