Bosch NBN-832 User Manual

en | Maintenance

DinionHD 1080p IP Camera

AM18-Q0600 | v1.0 | 2011.07

Installation Manual

Bosch Security Systems

Before the terminal program can communicate with the camera, 

the transmission parameters must be matched. Make the 

following settings for the terminal program:

–

19,200 bps

–

8 data bits

–

No parity check

–

1  stop  bit

–

No protocol

After the connection has been established, you must log on to 

the camera to access the main menu. Other submenus and 

functions can be accessed using the on-screen commands.

1.

If necessary, turn off the local echo so that entered values 

are not repeated on the display.

2.

Enter one command at a time.

3.

When you have entered a value, such as the IP address, 

check the characters you have entered before pressing 

Enter to transfer the values to the camera.

Before you can operate a camera in your network you must first 

assign it an IP address that is valid for your network.

The following default address is preset at the factory: 

1.

Start a terminal program such as HyperTerminal.

2.

Enter the user name service. The terminal program 

displays the main menu.

3.

Enter command 1 to open the IP menu.

4.

Enter 1 again. The terminal program displays the current IP 

address and prompts you to enter a new IP address.

5.

Enter the desired IP address and press Enter. The terminal 

program displays the new IP address.

6.

Use the displayed commands for any additional settings 

you require.