Siemens SIMATIC 505 User Manual
2-2
Installation
Series 505 High Speed Counter
and Encoder Module User
’s Manual
2.1
Before Installing the Module
2.1.1
Visual Inspection
Visual Inspection
If there is any visible damage to the module, contact your Siemens
Industrial Automation, Inc. distributor for replacement.
Industrial Automation, Inc. distributor for replacement.
2.1.2
Additional
Additional
Refer to the manuals listed below for instructions on installing,
References
programming, and troubleshooting your Series 505
E
controller.
D SIMATICr TI545
System Manual (PPX:545–8101)
D SIMATICr TI525
/
TI535
Hardware and Installation Manual
(PPX:505–8103)
D SIMATICr TI505
Programming Reference Manual (PPX:505–8104)
2.1.3
Handling the
Handling the
Many integrated circuit (IC) devices are susceptible to damage by the
Module
discharge of static electricity. Follow the suggestions listed below to reduce
the probability of damage to these devices when you are handling a
controller, a base controller, or any of the I/O modules.
the probability of damage to these devices when you are handling a
controller, a base controller, or any of the I/O modules.
Both the module and the person handling the module should be at the
same ground potential. To accomplish this, ensure the following.
same ground potential. To accomplish this, ensure the following.
D The module is transported in an anti-static container or antistatic
material.
D The work area has a conductive pad with a lead connecting it to a
common ground.
D You are grounded by making contact with the conductive pad and/or by
wearing a grounded wrist strap.