Pelco NET5308T-EXP User Manual
24
C2655M-A (10/08)
Figure 23. Connecting Alarms
CONNECTING POWER
The power supply incorporated into the NET5308T-EXP is tested and certified for high reliability applications. The unit has an autoranging power
supply that adapts automatically to voltages between 100 VAC and 240 VAC (50/60 Hz).
supply that adapts automatically to voltages between 100 VAC and 240 VAC (50/60 Hz).
For greater reliability, you can also install an uninterruptible power supply (UPS) (not supplied). UPS devices maintain a limited amount of backup
battery power in case the main power fails. The UPS should have a minimum rating of 200 VA for one NET5300B and two NET5308T-EXP units.
battery power in case the main power fails. The UPS should have a minimum rating of 200 VA for one NET5300B and two NET5308T-EXP units.
To connect power:
1. Connect one of the supplied US, European, or UK standard power cords to rear of the unit.
2. Connect the cord to the appropriate power source.
Refer to Unit Startup on page 26 to power up the unit.
CONNECTING SEQUENCE MONITOR
Use the SEQ output connector during installation to display video sequentially from each video input. The unit displays each channel for two
seconds. It displays a black screen for channels without video. Use this feature to verify camera installation.
seconds. It displays a black screen for channels without video. Use this feature to verify camera installation.
To display video from each connected video source:
1. Connect a video monitor to the SEQ output connector.
2. Start the NET5308T-EXP, the monitor, and each video source.
3. Verify the video from each source and troubleshoot as necessary.
A5
A6
A7
A8
100-200 VAC - 50/60 HZ
0.7 AMP
NO
C
NC
NO
C
NC
A
5