Barco ATLAS 67 CS4 User Manual

R5976255

     

A

TLAS

 CS4 (2001-03)

14-2

no display: lamp not ignited and fan of the
illumination unit not running

The equipment is not connected to power sup-
ply. It must be supplied with suitable voltage
(see

Power switch is off. Switch on power switch.
See 

The cover of the lamp housing is not installed
correctly, and the micro-switch in the housing
interrupts power supply. The cover sheet must
be fixed (see 

display is upside-down

change the configuration:
To change the configuration of the projector,
proceed as follows:

! 

Press 

 to start up the adjustment

mode.

! 

Press the cursor key 

 or 

 to select

.

! 

Press 

 to display the 

.

! 

Press the cursor key 

 or 

 to select

.

! 

Press 

 to display the 

. The actual installed configuration

will be highlighted.

Press the cursor key 

 or 

 to select the

corresponding configuration.

the display is dark though the lamp is ignited

there is no signal applied. Check the input source
and the connections

A

TLAS 

CS4 can not be controlled via the

point the front of the 

directly to the sensor

on the screen. When using the wireless remote
control, make sure you are within the effective
operating distance (30m, 100ft in a straight line).
The remote control unit will not function prop-
erly if strong light strikes the sensor window or
if there are obstacles between the remote control
unit and the IR sensor.

Table 14-1