Petsafe RFA-200 User Manual

 

www.petsafe.net 5 

Place the Fence Transmitter:

• In a dry, well ventilated, protected area (1A, 1B).
• In an area where temperatures do not fall below freezing (e.g., garage, basement, shed, closet).
• Secured to a stationary surface using appropriate mounting hardware (not included). A mounting template is 

included on the back of this guide.

• At least 3 feet from large metal objects or appliances as these items may interfere with the signal consistency (1C).

Once you have mounted the Fence Transmitter, the Boundary Wire must exit the building. This can be 
accomplished via a window or through a 1/8” hole drilled through the wall. Ensure the drill path is clear of any 
utilities. Make sure the Boundary Wire is not cut off or pinched by a window, door, or garage door, as this can 
damage it over time.

To prevent fi res and electrical hazards, install the Fence Transmitter in buildings that are in accordance with state 
and local electrical codes.

__________________________________________________

• The  Boundary Wire  MUST start at 

the Fence Transmitter and make a 
continuous loop back (2A).

• Design a layout that is suitable for your 

yard. Sample layouts are provided in 
this section, and a grid for designing 
your layout is provided on the back of 
this guide.

• Fence planning software is available 

online at www.petsafe.net. After you 
have planned and saved your layout 
online, contact our Customer Care 
Center to review and refi ne your layout.

• Twisting the Boundary Wire cancels 

the signal and allows your pet to cross 
over that area safely. Plastic or metal 

piping will not cancel the signal. Twist the Boundary Wire 10 to 12 times per foot to cancel the signal (2A).

• Always use gradual turns at the corners to produce a more consistent boundary (2B). Do not use sharp turns, 

as this will cause gaps in your boundary.

• Avoid making passageways too narrow for your pet to move about freely (e.g., along the sides of a house).• 

The Receiver Collar can be activated inside the house if the Boundary Wire runs along the outside wall of the 
house. If this occurs, remove your pet’s Receiver Collar before bringing him inside, decrease the range using 
the Boundary Width Control knob or consider an alternative layout.

1

2