Raymarine Pathfinder Radar RL70C PLUS User Manual
Chapter 2: Getting Started & Adjusting the Display
2-21
M
oving
A
roun
d t
he
Cha
rt
M
ovi
ng Ar
oun
d
th
e
Ch
art
the radar and chart images. It is recommended that you set the radar to True
motion to ensure the radar and chart images remain synchronised when the
vessel moves. When you press FIND SHIP the following occur:
motion to ensure the radar and chart images remain synchronised when the
vessel moves. When you press FIND SHIP the following occur:
•
The chart is redrawn so that its center position matches that of the radar dis-
play.
play.
•
The radar is redrawn to the scale and heading mode of the chart.
Note: Depending on the topology of the coastline, the radar returns may not
relate to the charted shoreline, the radar image will therefore be different to
the chart display. For example, a gently sloping beach with a cliff several hun-
dred metres beyond the charted coastline, the cliff is not shown on the chart
but will be displayed on the radar image.
relate to the charted shoreline, the radar image will therefore be different to
the chart display. For example, a gently sloping beach with a cliff several hun-
dred metres beyond the charted coastline, the cliff is not shown on the chart
but will be displayed on the radar image.
Changing the Chart Scale
The RANGE key allows you to change the chart scale so that you can see a
smaller or larger area on the screen.
smaller or larger area on the screen.
Plotter mode is available to allow you to zoom into a smaller area, even when
no chart data is available for that scale. Section 7.7 describes how to set plotter
mode on/off.
no chart data is available for that scale. Section 7.7 describes how to set plotter
mode on/off.
You can change the chart scale for two purposes:
•
To see either more detail (of a smaller area) or a larger area (in less detail)
on the screen.
on the screen.
•
To move the display to another area of the chart, by zooming out to a small
scale chart, then zooming in on another position centered on the cursor.
scale chart, then zooming in on another position centered on the cursor.
The cartographic detail available on charts varies according to the chart scale
and some areas include detail at smaller scales than others. This can cause
blank areas on the display when adjacent areas with different levels of detail
are displayed. To reduce this affect you can use the Chart Set Up options (see
Section 7.7) to set chart display detail to simple. Then, as you zoom in, charted
areas are displayed but with less detail shown.
and some areas include detail at smaller scales than others. This can cause
blank areas on the display when adjacent areas with different levels of detail
are displayed. To reduce this affect you can use the Chart Set Up options (see
Section 7.7) to set chart display detail to simple. Then, as you zoom in, charted
areas are displayed but with less detail shown.
Each time you press the RANGE key, the chart scale changes to the next
available setting. The status bar indicates the distance from top to bottom of
the screen, in nautical miles.
available setting. The status bar indicates the distance from top to bottom of
the screen, in nautical miles.
Figure 2-11: Changing the Chart Scale
RANGE
D4175_1
Increases the
chart distance
chart distance
Decreases the
chart distance
chart distance
Vertical distance
displayed on chart
displayed on chart
Status Bar
6nm
CSR 50 45'980N
POS 001 01'490W
POS 001 01'490W