Rosen Entertainment Systems CV1005 User Manual

Page of 4
Page 6
DANGER - AN IMPROPERLY LOCATED OR INSTALLED
MONITOR CAN CAUSE DEATH OR SERIOUS BODILY INJURY
READ THE FOLLOWING INFORMATION THOROUGHLY
BEFORE INSTALLATION
It is unlawful in most jurisdictions for a person to operate a
motor vehicle  equipped with a television monitor located
where the operator can directly or indirectly view it.
  In
some jurisdictions, television monitors in motor vehicles may be
prohibited or may require the television monitor to be located
behind the operators seat.
Ensure that you are completely aware of and familiar with
all applicable regulations and restrictions related to the use
of this equipment in a motor vehicle for your local jurisdic-
tion.
In the event of an accident, passengers can be thrown against
objects in the vehicle.  Ensure that the monitor location is in a
position where it will not be struck by a passenger in the
event of an accident.
ALWAYS mount the monitor securely using appropriate hardware
to a structural component in the vehicle.  Failure to properly
secure a monitor could result in the monitor coming loose
and endangering the passengers in the event of an acci-
dent.
The INSTALLER accepts all responsibility for proper installation
of the monitor.  Rosen Products, LLC, is not liable for any
damages, incidental or otherwise, which may result from
the installation of this product.
Release button
To lower the screen:
Press the release button as shown.
This will turn on the monitor (if the
ignition key switch is in the ACC or RUN
position).
Adjust the screen for best viewing angle
by turning the rotating adjustment here.
(Not available on CV1005).
To select an AUX source:
Press the 
Source button.
Each time the button is pressed, the screen will display
“AUX 1
AUX 1
AUX 1
AUX 1
AUX 1
” or “AUX 2
AUX 2
AUX 2
AUX 2
AUX 2
”.
To change the LCD display video settings:
Press the Up and Down buttons at the same time for
two seconds.
Follow the directions on the screen to select a setting to
modify, and use the Up and Down keys to change the
value of the setting.
To mute the audio:
Press the Mute button.
(Only affects audio routed through the video system -
may not affect the speakers in the vehicle). As long as
the Mute mode is active, an asterisk is visible in the text
display. Press the Mute button again to exit Mute mode.
To turn on and off an optional FM modulator:
Press the Speaker button. The screen will display
“Spkr On
Spkr On
Spkr On
Spkr On
Spkr On
” or “Spkr Off
Spkr Off
Spkr Off
Spkr Off
Spkr Off
”.
Page 1
Important Safety Notices
Quick Reference Guide