Sharp PN-E703 User Manual

47

E

5.  Click on “LAN SETUP” under NETWORK. 

6.  Specify the “DHCP CLIENT”, “IP ADDRESS”,etc. 

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an 

address automatically, change this setting to “ON”. 

To set the address manually, set this to “OFF”. 
IP ADDRESS
If the DHCP CLIENT is set to “OFF”, specify an IP address.
SUBNET MASK
If the DHCP CLIENT is set to “OFF”, specify the subnet mask.
DEFAULT GATEWAY
If the DHCP CLIENT is set to “OFF”, specify the default gateway. 

If you are not using a default gateway, specify “0.0.0.0”.

7.  When the setting is changed, click [Apply].

8.  Check the message and click [OK].

9.  Exit Internet Explorer. 

10. Restore the PC’s IP address jotted in Step 6, “(2) 

Specifying the PC’s IP address”. 

11. Connect the monitor and the PC to the LAN.

Caution

•  Wait 10 seconds after clicking [OK] before proceeding.

•  When operating using the remote control unit or similar, 

click [Refresh].

TIPS

•  When the IP address is set manually, the IP addresses of 

the monitor connected to the RS-232C output terminal and 

the daisy chain of connected monitors that follows can be 

assigned automatically. (See page 25.)

TIPS

•  For security, set a USER NAME and PASSWORD.

You use Internet Explorer on a PC on the LAN  to control the 

monitor.

1.  Launch Internet Explorer on the PC.

2.  In the “Address” box, type “http://” followed by your monitor’s 

IP address followed by “/”, then press the Enter key. 

You can confirm the IP address with the DISPLAY function.

When prompted to enter a user name and password, type 

the user name and password that you specified in the 

security settings (see page 49), and click [OK].

3.  You can check, control, and change the monitor’s status 

and settings by clicking the menu items on the left side of 

the screen. 

•  If you see an [Apply] button next to a setting, click it after 

you change that setting.

TIPS

•  See pages 48 to 52 for details on each setting. 

•  If you click [Refresh] before the screen finishes updating 

the current display, the “Server Busy Error” will appear. 

Wait for a moment before operating your monitor again. 

•  You cannot operate the monitor while it is warming up. 
•  If “DHCP CLIENT” is set to “ON”, press 

DISPLAY

 on the 

remote control unit two times and then check the monitor’s 

IP address.