Sharp PN-Y475 User Manual

38

E

Your monitor can be connected to a LAN allowing you to 

control it from a PC on the LAN. 

The connection requires a commercially available LAN cable 

(UTP cable, Category 5, straight through).

LAN terminal

LAN cable (commercially available, straight)

Network (LAN)

Hub

TIPS

•  You must assign an IP address to the monitor by following 

the procedures in “Settings to connect to a LAN”. (See the 

description on the right.)

•   To control the monitor via LAN, set STANDBY MODE to 

STANDARD.

•  If you will use RS-232C and LAN control simultaneously, 

maintain an interval of at least 100 ms between commands.

Set the monitor’s IP address and subnet mask to match the 

settings of your LAN. 

The settings depend on the configuration of your LAN. Ask 

your LAN administrator for details. 

Set the LAN SETUP options. (See page 27.)
After setting each item, press 

RETURN

.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an 

address automatically, change this setting to ON. 

To set the address manually, set this to OFF. 
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address. 
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask. 
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default 

gateway. 

If you are not using a gateway, specify “0.0.0.0”. 
DNS 1

DNS 2
Specify the DNS server address if the DHCP CLIENT is set 

to OFF.

If you are not using a DNS server, specify “0.0.0.0”.
NETWORK NAME
Enter the device name.

Input characters as follows when it is necessary.
Press 

ENTER

 to display the text entry table.

Select a character with 

 

 

 

, and press 

ENTER

 to 

enter. To change the characters entered, press 

DISPLAY

 (Red), 

MODE

 (Green), 

SIZE

 (Yellow).

To delete the previous character, press 

MUTE

.

When you are done entering characters, select [OK] and press 

ENTER

.