Sharp PN-E603 User Manual

45

E

Your monitor can be connected to a LAN allowing you to 

control it from a PC on the LAN. 

You can also configure the monitor to send e-mail notification 

when it has a problem. 

The connection requires a commercially available LAN cable 

(UTP cable, Category 5, straight through).

Hub

Network (LAN)

LAN terminal

LAN cable (commercially available, straight)

TIPS

•  You must assign an IP address to the monitor by following 

the procedures in “Settings to connect to a LAN”. (See the 

description on the right.)

•  Your PC must be installed with Internet Explorer (version 7.0 

or later). 

-   Version 7, 8, or 9 of Internet Explorer is recommended.

-   Use Internet Explorer Version 10 in compatibility mode.

•  While the monitor is in input signal waiting mode, control 

via LAN will be disabled.

•  When STANDBY MODE is set to LOW POWER, control is 

not possible in standby mode.

•   To control the monitor via LAN, set RS-232C/LAN SELECT 

to LAN. (See page 25.)

•  You cannot use RS-232C and LAN control simultaneously. 

•  Personal information such as e-mail addresses can be 

registered in the monitor. Before transferring or disposing of 

the monitor,  initialize all settings by selecting ALL RESET 

1. (See page 32.) Note that ALL RESET 2 will not initialize 

e-mail addresses and other settings.

Set the monitor’s IP address and subnet mask to match the 

settings of your LAN. 

These settings can be made on either the monitor or a PC 

connected to the monitor.

The settings depend on the configuration of your LAN. Ask 

your LAN administrator for details. 

Set RS-232C/LAN SELECT of COMMUNICATION SETTING 

on the SETUP menu to LAN, and then set the LAN SETUP 

options. (See page 25.)
After setting each item, select SET and press 

ENTER

.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an 

address automatically, change this setting to ON. 

To set the address manually, set this to OFF. 
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default 

gateway. 

If you are not using a gateway, specify “0.0.0.0”. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
RESET
Resets the values of the LAN settings to the factory preset 

values. 
Select ON and then press 

ENTER

.

TIPS

•  When the IP address is set manually, the IP addresses of 

the monitor connected to the RS-232C output terminal and 

the daisy chain of connected monitors that follows can be 

assigned automatically. (See page 25.)