Sharp PN-465E User Manual

ENGLISH

9

E

•  Since the monitor is heavy, consult your dealer before 

installation.

•  Installing or moving the monitor must be done by two or 

more people.

•  A stand and mounting bracket compliant with VESA 

specifications is required. Do not use any screw holes other 

than VESA holes for installation.

•  When moving the monitor, be sure to hold it with the 

handles both on the rear and the unit bottom. Do not hold 

the LCD panel. This may cause product damage, failure, or 

injury.

•  Install the monitor with the surface perpendicular to a 

level surface. If necessary, limit the tilt between 0 and 20 

degrees downward.

•  Mounting the monitor on the wall requires special expertise 

and the work must be performed by an authorised SHARP 

dealer. You should never attempt to perform any of this 

work yourself. Our company will bear no responsibility 

for accidents or injuries caused by improper mounting or 

mishandling.

•  This monitor should be used at an ambient temperature 

between 0°C and 40°C. Provide enough space around the 

monitor to prevent heat from accumulating inside.

20

Unit: cm

5 

5

5

Unit: cm

*

*

5

5

5

20

*   The monitor can be installed close to a wall, etc. 

However, the monitor emits heat during operation. Be 

aware that heat emitted from the monitor may discolour 

or alter the wall.

  If it is difficult to provide such space because the monitor is 

installed inside a housing or for other reasons, take other 

measures to keep the ambient temperature between  

0°C and 40°C such as installing a fan in the housing.

•  Adhere to the following when installing the monitor in the 

vertical orientation. Failing to adhere to the following may 

cause malfunctions. 

-  Install the monitor such that the power LED is located on 

the downside.

- Set the MONITOR on the SETUP menu to PORTRAIT.

(See page 19.)

•  Do not block any ventilation openings. If the temperature 

inside the monitor rises, this could lead to a malfunction.

•  After mounting, it is recommended to take some measures 

to prevent the monitor from falling down.

•  Do not place the monitor on a device which generates heat.

•  Be sure to use a stand or a wall-mount/ceiling-mount 

bracket designed or designated for mounting the monitor.

•  This monitor is designed to be installed on a concrete wall/

ceiling or pillar. Reinforced work might be necessary for 

some materials such as plaster / thin plastic board / wood 

before starting installation. 

This monitor and bracket must be installed on a wall which 

can endure at least 4 times or more the weight of the 

monitor. Install by the most suitable method for the material 

and the structure.

•  Use the supplied vertical logo sticker when you install the 

monitor in vertical orientation.

*

INPUT

*   Do not remove the factory-affixed sticker but affix the logo 

sticker over it. Be careful not to cover the remote control 

sensor or buttons.