Kenwood DDX3048 User Manual

English

•  You cannot change <Audio> settings (except <Preout Setup>) when the unit is in standby.

Initial: Underlined

Fader : Adjust the front and rear speaker output balance.
♦ F6 to R6; Initial 0
•  When using a two-speaker system, set the fader to the 

center (0).

Balance : Adjust the left and right speaker output balance.
♦ L6 to R6; Initial 0
Press [ 

5/∞/2/3 ] or drag [   ] to adjust.

•  To clear the adjustment, press [Center].

Change the sound mode or adjust and store the equalization 
for each source. (☞ page 28)
♦ Natural/Rock/Pops/Easy/Top40/Jazz/User

You can activate/deactivate the loudness function.
♦ OFF
♦ ON

: Cancels.
:  Boost low and high frequencies to 

produce a well-balanced sound at a low 
volume level. The LOUD indicator lights up.

Adjust the cross over frequency. (☞ page 29)

Adjust and store the auto-adjustment volume level for each 
source. (For discs, the adjustment is stored for each of the 
following categories: DVD/DVD-VR, VCD/CD, and DivX/
MPEG1/MPEG2/MP3/WMA/WAV/AAC.) The volume level will 
automatically increase or decrease when you change the 
source.
♦ –15 to +6; Initial 0

1

♦ Rear

:  Select this when rear speaker is connected 

to REAR/SW jacks through an amplifier.

♦ Subwoofer :  Select this when subwoofer is connected 

to REAR/SW jacks.

2

♦ ON
♦ OFF

:  Activates the subwoofer.
: Cancels.

Select the size of the connected speaker.
♦ Standard/Narrow/Middle/Wide

*

1 

You can change the setting only when the unit is in standby.

*

2 

Selectable only when <Subwoofer> is selected for <Preout Setup>.

EN_DDX_K.indb   35

EN_DDX_K.indb   35

10/12/20   18:36

10/12/20   18:36