Sony NSR-1050H User Manual
NSR-1000 Series v1.1.1 Release Note
５-２ Histories of resolved limitations
５-２-１ Resolved limitations in V1.1.0
５-２-１-１ Main Window – Monitoring
・
There are cases where a camera does not move even if you select the preset
position which is already configured and appears in the preset list. This
problem may happen when you move a camera in the ways other than selecting
the preset position after moving it to the present position once on the main
screen. To work around this, select the other position once and then reselect the
desired position in the preset list. (V11N:76)
position which is already configured and appears in the preset list. This
problem may happen when you move a camera in the ways other than selecting
the preset position after moving it to the present position once on the main
screen. To work around this, select the other position once and then reselect the
desired position in the preset list. (V11N:76)
５-２-１-２ Device Configuration
・
If specifying an IP address which is not connected to the camera and clicking
[OK] button, it takes about ten minutes to detect the error. (V11N:9,V11N:27)
[OK] button, it takes about ten minutes to detect the error. (V11N:9,V11N:27)
・
If registering two or more Barix-made Barionet I/O devices, all pins
incorporated in all the registered Barionet devices are displayed in random
order under [Barionet] in the device tree. To work around this, use the single
Barionet device. (V11N:78)
incorporated in all the registered Barionet devices are displayed in random
order under [Barionet] in the device tree. To work around this, use the single
Barionet device. (V11N:78)
・
When manual recording is performed when monitoring an AXIS camera with
MPEG4 codec selected, there are cases where no image/audio is recorded for the
first 5 seconds. (V11Ｎ:423)
MPEG4 codec selected, there are cases where no image/audio is recorded for the
first 5 seconds. (V11Ｎ:423)
・
When you reboot AXIS camera and have recording or action schedules which
uses AXIS camera input pin for event trigger, there are some cases where these
schedules doesn’t work correctly. To enable the schedules, be sure to deselect
the [Enable] checkbox and apply in that camera’s [Sensor In] tab, and then
select the [enable] check box again and apply. (VT1:2203)
uses AXIS camera input pin for event trigger, there are some cases where these
schedules doesn’t work correctly. To enable the schedules, be sure to deselect
the [Enable] checkbox and apply in that camera’s [Sensor In] tab, and then
select the [enable] check box again and apply. (VT1:2203)
５-２-１-３ Schedule Configuration
・
The problem that occurs when configuring the event/alarm actions
If you change the tour setting in the device menu while the Preset/Tour on
[Camera Action] tab is already made, the value of [Action end preset] that was
[Camera Action] tab is already made, the value of [Action end preset] that was
- 36 -