Furuno MU-190 User Manual

Adjust the MU-190 according to the equipment connected.

Note: Sections 2.2, 2.3 and 2.4 are for Non-SOLAS.

The [INSTALLATION SETTING] menu appears only when the power is turned on for the first time 
after installation.

For ECDIS (FEA-2107) or chart radar (FCR-21x7), no adjustment is necessary. Keep this equip-
ment in the default settings.

For IMO radar (FAR-21x7) or Non-SOLAS, adjust this equipment according to the equipment con-
nected, referring to the following table.

Gray items: Default setting

*1: To connect to the processor unit of a radar, connect the video signal cable to the DVI-D1 port. 
Then, select DVI1 to display the radar picture (see section 3.4).

*2: "DVI PWR SYNC" is the slide switch at the bottom rear of the monitor unit. See the “Slide 
switch” below.

Slide switch

Set the slide switch (located between RGB and DVI ports) to OFF when you connect the RGB 
signal or both RGB and DVI signals. Otherwise, the monitor will not turn on. The slide switch is set 
at the factory to ON to control the power on/off from the equipment connected via DVI signal.

FEA-2107, FCR-21x7

RS-232C

9600

ON

ON

ON

FAR-21x7

DVI *1

-

OFF

ON

ON

Other

OFF

-

OFF

OFF

OFF

 

INSTALLATION SETTING

EXT BRILL CTRL

SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK

SAVE AND EXIT

RS-232C

9600bps

ON
ON

YES

(OFF/DVI1/DVI2/RS-232C/RS-485/USB)

(4800/9600/19200/38400)
(OFF/ON)
(OFF/ON)

(NO/YES)

Menu

Menu item

Slide switch ON (Default setting)

䋨Ꮏ႐಴⩄ᤨ䈱⁁ᘒ䋩

Slide switch

ON (Default setting)

DVI port

OFF

RGB port