Directed Video HRB100 User Manual

1.

Remove the headrest cover to determine if
it has room in it for the monitor without
structurally weakening it.

2.

With the cover still removed, position the
cutout template against the rear of the
headrest and mark the area to be cut out. 

3.

Remove the material to a depth sufficient
for the lip of the mounting bezel to fit
flush against the rear of the headrest once
installed.

4.

Cut an access hole for the cable to exit
next to the headrest adjustment bar.

5.

Reinstall the headrest cover. Trim it 1”
smaller than the size of the mounting buck-
et hole. When trimming, it is best to leave
extra material that can be glued into the
hole before installing the mounting bucket.

6.

Route the cable through the headrest
access hole and the rear opening of the
mounting bucket.

7.

Install the bucket. Some headrests have
material that is strong enough to screw
the bucket into. Others will require quality
adhesive for mounting or tie straps to
secure it to the metal support bars. 

8.

Route the cable through the seat cover
and reinstall the headrest. Leave enough
slack in the cable so the headrest still has
full movement during adjustment.

9.

Complete the cable routing to the video
source.

Place the monitor directly in front of the buck-

et and line up the hot foot connector on the

bracket. Place your thumb on the top and press

firmly until it locks into place. Then place your

thumb on the bottom of the monitor and press

firmly until it locks into place also.

Pull gently on the lower bracket tab and lift the

monitor to the maximum angle. Reach under the

bracket and pull down on the release tab. With the

monitor released, lift it off the mounting bracket.

© 2003 Directed Electronics, Inc.  

Release Tab

N87301 1-03.qxd  5/6/2003  8:47 AM  Page 9