Barco K5960051-01 User Manual
214 Barco - RHDM-1701 - User manual
Addendum
7.8.3.2.3
Remove the Barco stand
Instructions to remove the Barco stand from the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, covered with bub-
ble wrap or a similar protective material.
• Unscrew the 4 knurled screws and remove the tiltable stand. Mount the 4 knurled screws again
on the VESA mounting positions.
7.8.4 Connecting signals and power to the display unit
7.8.4.1 Instructions to power up the display unit
Figure 76: Power connection
The display unit should be powered with the 100-240Vac power input within the operational
tolerances. The display unit communicates the status of the power supply via the indicator lights.
Please check the section that deals with the indicator lights in the chapter “Full functionality
description” for more information.
tolerances. The display unit communicates the status of the power supply via the indicator lights.
Please check the section that deals with the indicator lights in the chapter “Full functionality
description” for more information.
CAUTION
:
Before connecting the display unit to mains, check if the power source voltage corresponds to the mains voltage
marked on the identification label on the display.
marked on the identification label on the display.
1
Earth stud
2
100-240 Vac in
3
Power switch
2
3
1