Land Pride RCR1248 User Manual
26
Section 5: Maintenance & Lubrication
RCR1248, RCR1260 and RCR1272 Rotary Cutter 326-047M
12/15/15
Gearbox
Remove rear oil plug (#2). If oil is below bottom of plug
hole, add recommended gear lube through top vented plug
hole until oil flows out of rear plug hole. Reinstall and
tighten rear oil plug (#2) and top vented plug (#1).
hole, add recommended gear lube through top vented plug
hole until oil flows out of rear plug hole. Reinstall and
tighten rear oil plug (#2) and top vented plug (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil begins to flow out rear plug hole in
gearbox.
gearbox.
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore, always
check oil level when cold.
checking oil. Oil expands when hot, therefore, always
check oil level when cold.
8
Hours
30300
Do Not Overfill!
NOTE: Use a suction or siphon pump to drain
gearboxes of oil when there is not an oil drain plug.
gearboxes of oil when there is not an oil drain plug.