Land Pride RC4015 User Manual

10/21/15

8.

Remove locknuts (#1) and bolts (#2) from bolted 
coupler end of driveline (#9).

9.

Insert bolted coupler end of driveline (#9) through 
gearbox shield (#10) and attach to gearbox input 
shaft (#8) with removed bolts (#2) and locknuts (#1). 
Tighten locknuts to the correct torque.

10. Return gearbox shield (#10) to mounting plate (#4) 

and secure with latches (#5).

11. Check safety chain (#3). Make sure it is latched to 

mounting plate (#4) and gearbox shield (#10).

12. Rotate driveline hanger (#11) up and support 

driveline (#9) on hanger. Final adjustments to hanger 
will be made after tractor hook-up.

37520

37904

The main driveline can be constant velocity type or 
conventional type. Pull-collar and bolted couplers are 
used to secure the driveline to the tractor and implement 
gearbox, respectively. 

1.

Remove hex whiz nuts (#4A), carriage bolts (#3), and 
shipping bracket (#2). Discard shipping bracket.

2.

Slide driveline (#5) off end of shipping bracket (#1). 
Set driveline aside for attaching to splitter box later.

3.

Reinsert carriage bolts (#3) and secure with hex whiz 
nuts (#4A). Tighten whiz nuts to the correct torque.

4.

Remove hex whiz nuts (#4B), carriage bolts (#3), and 
shipping bracket (#1). Discard shipping bracket.

5.

Reinsert carriage bolts (#3) and secure with hex whiz 
nuts (#4B). Tighten whiz nuts to the correct torque.

6.

Unsnap latches (#5) on both sides of gearbox 
shield (#10) and remove gearbox shield.

7.

Remove and discard rubber shaft protector (#7) from 
splitter gearbox shaft (#8). 

IMPORTANT: The driveline must be lubricated 
before putting it into service. Refer to “Lubrication 
Points” on page 46.

NOTE:  Wings must be lowered before removing the 
driveline from its shipping location. See “Lower 
Wings” on page 18.