Land Pride RC4015 User Manual
34
Section 4: Options & Accessories
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
10/21/15
Mechanical Wing Lift
330-295A Mechanical
Winch
Refer to Figure 4-1:
An optional manual wing lift kit is available for raising the
wing to transport position when the hydraulic system is
not working or when the towing vehicle is not equipped
with the proper hydraulic connections.
wing to transport position when the hydraulic system is
not working or when the towing vehicle is not equipped
with the proper hydraulic connections.
Pull hook (#5) with cable out. Attach cable to wing deck
by routing the cable around the cylinder pin between the
clevis brackets and clipping the hook back to the cable.
The cylinder rod end will need to be disconnected from
the wing if the rod will not retract.
by routing the cable around the cylinder pin between the
clevis brackets and clipping the hook back to the cable.
The cylinder rod end will need to be disconnected from
the wing if the rod will not retract.
Installation Instructions
Attach mechanical winch mounting frame (#1) to the
center deck in the location shown with 5/8"-11 x 2" GR5
cap screws (#2), flat washers (#4), and hex flange lock
nuts (#3). Tighten nuts to the correct torque.
center deck in the location shown with 5/8"-11 x 2" GR5
cap screws (#2), flat washers (#4), and hex flange lock
nuts (#3). Tighten nuts to the correct torque.
Mechanical Winch
Figure 4-1
Cylinder Pin
Operating Instructions
!
DANGER
!
DANGER
1.
Pull cable hook with cable out past the gearbox.
2.
Attach cable to wing deck by routing cable around the
wing gearbox base and clipping the hook back to the
cable or by hooking the cable to the wing deck side
panel. Make certain the cable is secured and will not
slip or come loose before raising the deck up.
wing gearbox base and clipping the hook back to the
cable or by hooking the cable to the wing deck side
panel. Make certain the cable is secured and will not
slip or come loose before raising the deck up.
3.
Turn mechanical winch handle to raise deck. If
cylinder rod will not retract while raising the wing up,
loosen hydraulic fitting on the rod side of the cylinder
to allow intake of air while raising the wing.
cylinder rod will not retract while raising the wing up,
loosen hydraulic fitting on the rod side of the cylinder
to allow intake of air while raising the wing.
4.
Secure wing deck in the raised position with cylinder
transport lock. See “Transport Locks” instructions
on page 30.
transport lock. See “Transport Locks” instructions
on page 30.
5.
Retighten hydraulic fitting if loosened.
6.
Lower wing deck as follows:
If hydraulic fitting was not loosened:
a. Unhook cable and reel cable up.
a. Unhook cable and reel cable up.
b. Connect hydraulic hose to a tractor and lower
wing deck with tractor control lever.
If hydraulic fitting was loosened:
a. Loosen hydraulic fitting at the cylinder to allow
a. Loosen hydraulic fitting at the cylinder to allow
intake air to escape while lowering the wing deck.
b. Remove transport lock and lower wing deck with
mechanical winch.
c. Retighten hydraulic fitting and connect all
hydraulic hoses to a tractor.
d. Purge hydraulic system of air. See “Purge