Land Pride RC4015 User Manual

10/21/15

12. Red wires in connectors (#1A & #1B) are attached to 

pin “D” shown in Detail B. Plug connectors (#1A & 
#1B) together.

13. Yellow wires in connectors (#2A & #2B) are attached 

to pin “B” Shown in Detail B. Plug connectors (#2A & 
#2B) together.

14. Route wire harnesses (#17 & #18) to enhance 

module (#19). Plug connectors at the enhance 
module to harness (#17 & #18) as follows:

a. Red wires in connectors (#1C & #1D) are 

attached to pin “B” as shown in Detail B. Plug 
connectors (#1C & #1D) together.

b. Yellow wires in connectors (#2C & #2D) are 

attached to pin “C” shown in Detail B. Plug 
connectors (#2C & #2D) together.

15. Attach connector (#3A) to connector (#3B) on lead 

wire harness (#20).

16. Route lead wire harness through spring hose 

loop and connect to the tractor’s 7-way round pin 
receiver. 

17. Start tractor and operate lights to verify hook-up is 

operating properly:

a. Turn on head lights to verify red lights illuminate.

b. Operate turn signal to turn right. Amber light on 

the right side should blink on and off.

c. Operate turn signal to turn left. Amber light on the 

left should blink on and off. 

18. If the lights did not operate properly, recheck hook-up 

of wire harnesses (#17 & #18). Make necessary 
changes to the harnesses and repeat step 17 above.

19. Recheck wire harness routing to make sure wires will 

not be pinched as wing decks are folded and 
unfolded and while raising and lowering cutter height.

20. Add cable ties (#5) to wire harnesses (#17, #18, & 

#20) as needed to secure them in place.