Land Pride RC4015 User Manual

Section 5: Maintenance & Lubrication

RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M

10/21/15

Gearbox

Method 1: Unscrew top vented dipstick (#1). Wipe oil
from dipstick and screw dipstick in without tightening.
Unscrew dipstick and check oil on dipstick. If below
bottom level mark, add recommended gear lube through
dipstick hole until oil reaches top mark on dipstick.
Reinstall vented dipstick and tighten.

Method 2: Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).

Type of Lubrication: 80-90W EP Gear Lube

Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox

IMPORTANT: Do not overfill gearbox with oil! Oil will
expand when hot! Make sure cutter is level and oil is
cool before checking oil level.

Oil Level Plug

Oil Drain Plug

23603

Oil Fill Plug

Divider Box

Instructions: Remove oil level plug. If oil is below bottom
of plug hole, add recommended gear lube through oil
fill/vent plug hole until oil flows out of oil level plug hole.
Reinstall and tighten oil level plug and oil fill/vent plug.

Type of Lubrication: 80-90W EP

Quantity = Fill until oil begins to flow out oil level plug hole
in gearbox.

IMPORTANT: Do not overfill gearbox with oil! Oil will
expand when hot! Make sure cutter is level and oil is
cool before checking oil level.

If oil has been removed from the gearbox, refill
gearbox to level plug, allow time for air to bleed up
from the lower cavity, and then recheck.

30215

Do Not Overfill

NOTE: Use a suction or siphon pump to drain
gearbox of oil when there is not an oil drain plug.

Hours