Land Pride RCF2784 User Manual
12
Section 1: Assembly & Set-up
RCF2784 Rotary Cutters 326-364M
12/15/15
33270
23998
Driveline Installation
Figure 1-5
3-Point Tractor Hook-up
Refer to Figure 1-5:
!
DANGER
A tractor with 3-Point Category lI or lII hitch is required.
The lower 3-Point arms must be stabilized to prevent
side-to-side movement. Most tractors have sway blocks
or adjustable chains for this purpose.
The lower 3-Point arms must be stabilized to prevent
side-to-side movement. Most tractors have sway blocks
or adjustable chains for this purpose.
1.
Slowly back tractor to the Rotary Cutter while using
tractor’s 3-Point hydraulic control lever to align lower
3-Point arm hitch holes with clevis hitch pin holes.
tractor’s 3-Point hydraulic control lever to align lower
3-Point arm hitch holes with clevis hitch pin holes.
2.
Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
and remove key before dismounting from tractor.
3.
Attach lower 3-Point arms to clevises with hitch
pins (#1) and if required adapter bushings (#12).
Secure hitch pins with linch pins (#6).
pins (#1) and if required adapter bushings (#12).
Secure hitch pins with linch pins (#6).
4.
Connect upper center 3-Point link hitch hole to upper
hitch with clevis pin (#7) and hairpin cotter (#5).
hitch with clevis pin (#7) and hairpin cotter (#5).
NOTE: Driveline installation instructions will follow
after hooking-up cutter to tractor. This is because
the distance between tractor PTO shaft and gearbox
input shaft can vary from tractor to tractor.
after hooking-up cutter to tractor. This is because
the distance between tractor PTO shaft and gearbox
input shaft can vary from tractor to tractor.
NOTE: Land Pride’s QH20 Cat. II Quick Hitch can
be attached to the tractor to provide quick and easy
3-Point hook-up and detachment. See your nearest
Land Pride dealer to purchase a QH20 Quick Hitch.
be attached to the tractor to provide quick and easy
3-Point hook-up and detachment. See your nearest
Land Pride dealer to purchase a QH20 Quick Hitch.
NOTE: Adapter bushings (#13) are used if tractor
3-Point hitch is Cat. lll. The bushing can also be
used when using a Quick Hitch.
3-Point hitch is Cat. lll. The bushing can also be
used when using a Quick Hitch.
5.
Return to tractor and slowly and carefully raise and
lower cutter to ensure drawbar, tires, and other
equipment on the tractor do not contact cutter frame.
Move or remove drawbar if it interferes with cutter.
lower cutter to ensure drawbar, tires, and other
equipment on the tractor do not contact cutter frame.
Move or remove drawbar if it interferes with cutter.
6.
Manually adjust one of the lower lift arms up or down
to level the Rotary Cutter from left to right.
to level the Rotary Cutter from left to right.
7.
Manually adjust length of top-center-link to align
center hitch pin vertically above lower hitch pins.
Final deck leveling adjustments will be made later.
center hitch pin vertically above lower hitch pins.
Final deck leveling adjustments will be made later.
8.
The tractor’s lower 3-Point arms should be adjusted
for lateral float. Please consult your tractor’s manual
for adjusting instructions.
for lateral float. Please consult your tractor’s manual
for adjusting instructions.
Driveline Installation
!
DANGER
!
DANGER
!
WARNING
!
WARNING