Land Pride RCF2784 User Manual

12/15/15

33269

1.

Install tailwheels (#26) to axle frame (#5) with hex 
flange lock nuts (#14). Tighten lock nuts to the correct 
torque. 

2.

Attach axle frame (#5) to rear deck lugs with 
3/4"-10 x 2 1/2" GR5 cap screws (#10), spacer 
tubes (#1), flat washers (#15), and lock nuts (#11). 
Tighten nuts to the correct torque.

3.

Install ratchet jack (#7) or hydraulic cylinder (#8) to 
deck assembly as follows:

Ratchet Jack Installation:

a. Attach base of ratchet jack (#7) to mounting lugs 

behind gearbox with 1" x 4 3/4" clevis pin (#21) as 
shown. Secure clevis pin with hairpin cotter (#19).

b. Operate ratchet lever to extend or shorten ratchet 

jack until spring cushioned end of ratchet jack 
aligns with hole in axle frame (#5).

c. Insert 1" x 3 3/16" clevis pin (#20) and secure with 

hairpin cotter (#19).

NOTE:  Tailwheel on right-hand side is not shown to 
allow easier viewing of balloons.

Hydraulic Cylinder Installation:

a. Screw vent plug (#9) into port on rod end of 

cylinder (#8) until tight.

b. Screw O-ring end of 9/16" straight adapter (#24) 

into port of base end of cylinder (#8) until tight.

c. Screw hydraulic hose (#25) to straight adapter 

(#24) until tight.

d. Attach quick coupling (coupling supplied by 

customer) at tractor end to hydraulic hose (#25) 
until tight.

e. Attach base end of hydraulic cylinder (#8) 

between and to mounting lugs behind gearbox 
with 1" x 4 3/4" clevis pin (#21). Secure clevis pin 
with hairpin cotter (#19).

f. Extend hydraulic cylinder until clevis on spring 

cushioned end (#6) straddles lug on axle 
frame (#5) and holes in clevis aligns with hole in 
axle frame lug.

g. Insert 1" x 2 3/4" clevis pin (#16) and secure with 

hairpin cotter (#19).

4.

Screw coupler nut (#13) onto long leveling rod (#3) 
about 1 3/4".

5.

Screw jam nut (#12) onto the short leveling rod (#2) a 
distance of about 1 3/4".

6.

Screw short leveling rod (#2) into coupler nut (#13) 
until coupler nut is against jam nut (#12).