Husqvarna 115 09 83-95 User Manual

English

„

SWIVEL JOINT

1. Connect the blower and swivel joint with flexible hose. Clamp both 

ends of the flexible hose securely with the hardware supplied with the 
unit.

„

THROTTLE LEVER [130BT/150BT/170BT/180BT]

1. Set up the throttle holder to the swivel and tighten the screw on the 

holder.

When setting up the holder, please make sure to match the holder to the 
convex on the swivel joint as shown in F2.

2. Adjust the position and angle to achieve a comfortable working 

position, and tighten the throttle lever.

„

THROTTLE CABLE [130BT/150BT/170BT/180BT] 

[130BT]
• Fasten the throttle cable at central position of the hose by the band 

attached to the throttle cable.
First, wrap the hose with the band fixed to the throttle cable from the 
lower side.
Then, pass the band through a hole of the band as shown in figure.
Please note that there is a possibility of damaging the hose if the 
band is fastened too tightly.

[150BT] [170BT] [180BT] 
• Use the clamp to fasten the colgate tube containing the throttle cable 

and the power cable to the hose.

„

RIGHT HANDLE [150BF/170BF/180BF] 

• Insert the handle holder to the swivel and tighten the screw on the 

holder.

When setting up the holder, please make sure to match the holder to the 
convex on the swivel joint as shown in F5.

„

HANDLEBAR [OPTION] [130BT/150BT/170BT/

180BT]

1. Insert the holder, then assemble the handlebar (OPTION) and tighten it 

securely.

F1

(1)

(2)

F2

F3

(1)

F4

F5

F6

Assembly

130BT&180BT_US-65.fm  Page 14  Friday, December 7, 2007  1:05 PM