Poulan CL36A User Manual

7

02091

02085

CAUTION:  Container support is spring 
loaded and locked to the cover.  Handle 
cover assembly carefully so as not to 
unlatch the cover from the container 
support.  

1.    Rotate cover assembly onto its side as shown.
2.   Assemble support post to container support with 

the three (3) carriage bolts and locknuts. Tighten 
securely.

1.    Align mark on seal with mark at cover opening.
2.    Work seal into opening so cover sits between fl anges 

of seal.

NOTE: If your tractor already has four (4) shoulder bolts 
installed on the rear draw bar, simply hang the mounting 
bracket, lanced tabs towards bottom, on the bolts. Discard  
hardware group "A" and disregard the remaining Step 1 
instructions.

If your tractor does not have four (4) shoulder bolts installed 
on the drawbar, follow the instructions below.

Only one set of hardware in GROUP "A" will be used to 
mount the rear mounting bracket.  To determine which set 
is correct for your tractor, check to see if there are (2) two 
upper corner ribs on each side of drawbar.  If your tractor 
has the upper corner ribs, use the (4) four self tapping 
shoulder bolts. If your tractor does not have the corner ribs, 
use the set of (4) four bolts and locknuts.

SELF TAPPING SHOULDER BOLTS (See Fig. 1B)
1.    Using the four formed holes in the drawbar, install the 

four shoulder bolts as shown and tighten securely.

2.      Hang the mounting bracket, lanced tabs towards bottom, 

on the bolts.

02

33

7

02

33

6

BOLTS AND LOCKNUTS (See Fig. 1C)
1.    Assemble the mounting bracket, lanced tabs towards 

bottom, using the four smaller inside holes on the 
drawbar.

2.    Install the four bolts and locknuts as shown and tighten 

securely.

02335