Husqvarna 525 88 56-01 User Manual

8

ASSEMBLY

Frame Bracket

Hanger

Cover Assembly

For ease of assembly, you may wish assistance from 
another person for mounting the cover assembly to 
mower.

Position cover assembly on the ground behind the 

1. 

mower.
Lift and rotate cover to align the frame bracket 

2. 

with the hanger and slide the cover down until 
secure.

Remove plastic end cap from the center bag 
support arm. Fully insert spacer plugs into the 
ends of the support tube. It may be necessary 
to tap the spacer into place with a hammer or 
mallet. Replace the plastic end cap back over 
the spacer. The additional extension will hold the 
hood more securely when latched.

Using hardware provided in kit, attach support 

1. 

mount to unit.
Attach hanger bracket to support mount. Do not 

2. 

fully tighten nuts at this time.

Secure rear end of support straps to outside of 

3. 

hanger assembly. Set reinforcement plates to the 
outside of the tank brackets and fasten front end 
of support strap to tank bracket and reinforcment 
plate with round head bolt. Secure front end 
of reinforcement plate to tank bracket with hex 
bolt. Fully secure all mounting hardware. See 
illustration. 
NOTE: Depending on model, rear guard hole may
need to be drilled out to

Remove center 
end cap

Insert spacer and 
replace cap

Support Straps

Reinforcement Plate

Round Head 
 Bolt Placement

Hex Bolt Placement

Hanger Bracket

Support Mount