Snapper 1721303-01 User Manual
13
Initial Setup & Assembly
Figure 13. Control Rod Support
A. Angling Support
A. Angling Support
D. 5/16 Flatwasher
B. Eyebolt & Locknut
E. Flange Locknuts
C. 5/16-18 x 1-1/2 Capscrews
Install Angling Control Rod
NOTE: If installing the dozer attachment on a unit
equipped with a snowcab, replace the control rod sup-
port (A, Figure 13) with the hanging support (Ref. No. 19,
Figure 8). Mount the hanging support to the front cab
cross-bar.
equipped with a snowcab, replace the control rod sup-
port (A, Figure 13) with the hanging support (Ref. No. 19,
Figure 8). Mount the hanging support to the front cab
cross-bar.
1. Set the angling control support (A, Figure 13) against
the right side of the frame. Insert two 5/16-18 x 1-1/2
capscrews (C) through the support (A), and frame.
Space the lower hole away from the frame with a
5/16 washer (D). Secure using flange locknuts (E).
capscrews (C) through the support (A), and frame.
Space the lower hole away from the frame with a
5/16 washer (D). Secure using flange locknuts (E).
2. Install the eyebolt (B) in the support (A) and secure
with a centerlock nut.
A
B
C
D
E
Figure 14. Assemble Control Rods
A. 1/4-20 Centerlock Nut
B. Eyelet
C. Upper Control Rod
D. 5/16-18 x 1-1/4 Capscrew
E. 5/16 Washers, Lockwashers, & Nuts
F. Lower Control Rod
G. Hair Pin Clip & Washer
A. 1/4-20 Centerlock Nut
B. Eyelet
C. Upper Control Rod
D. 5/16-18 x 1-1/4 Capscrew
E. 5/16 Washers, Lockwashers, & Nuts
F. Lower Control Rod
G. Hair Pin Clip & Washer
A
B
C
D
F
G
E
3. Connect the lower angling rod (F, Figure 14) to the
dozer release lever using a hair pin clip and washer
(G).
(G).
4. Insert the upper control rod (C) through the eyelet
(B), and secure the eyelet to the support using a 1/4-
20 centerlock nut (A).
20 centerlock nut (A).
NOTE: It may be necessary to leave the eyebolt nut (A,
Figure 14) loose to prevent binding.
Figure 14) loose to prevent binding.
5. Secure the upper rod (C) to the lower rod (F) using
two 5/16-18 x 1-1/4 capscrews (D), washers (qty. 4),
lockwashers, and nuts (E). NOTE: Match offset to
offset so the rods form a straight line.
lockwashers, and nuts (E). NOTE: Match offset to
offset so the rods form a straight line.