Black & Decker LSW20B User Manual

Page of 28
Recommended minimum wire size for Extension Cords
Do not expose charger to rain or snow.
pull by plug rather than cord when disconnecting charger. 
This will reduce risk of damage to electric plug and cord.
make sure that cord is located so that it will not be stepped 
on, tripped over, or otherwise subjected to damage or stress.
Do not use an extension cord unless it is absolutely 
necessary. Use of improper extension cord could result in risk of 
fire, electric shock, or electrocution.
•  Do not place any object on top of charger or place the 
charger on a soft surface that might block the ventilation 
slots and result in excessive internal heat. Place the charger 
in a position away from any heat source. The charger is 
ventilated through slots in the top and the bottom of the housing.
•  Do not mount charger on wall or permanently affix charger 
to any surface. The charger is intended to use on a flat, stable 
surface (i.e., table top, bench top).
Do not operate charger with damaged cord or plug — have 
them replaced immediately.
Do not operate charger if it has received a sharp blow, been 
dropped, or otherwise damaged in any way. Take it to an 
authorized service center.
Do not disassemble charger; take it to an authorized service 
center when service or repair is required. Incorrect reassembly 
may result in a risk of electric shock, electrocution or fire.
4
ImpORtAnt sAFEty InstRuCtIOns                        
fOR BATTERY CHARGERS
This manual contains important safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
wARnInG: 
shock hazard. Do not allow any liquid
to get inside charger.
wARnInG: 
Burn hazard. To reduce the risk of
injury, charge only designated Black+Decker batteries. Other types
of batteries may burst causing personal injury and damage.
CAutIOn: 
 Under certain conditions, with the
charger plugged in to the power supply, the charger can be shorted
by foreign material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities. Always
unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
wARnInG:
the charger supplied with this product is intended to be 
plugged in such that it is correctly orientated in a vertical or 
floor mount position.
DO nOt attempt to charge the battery pack with any chargers 
other than the ones in this manual. The charger and battery 
pack are specifically designed to work together. 
these chargers are not intended for any uses other than 
charging designated Black+Decker rechargeable batteries. 
Any other uses may result in risk of fire, electric shock or electrocution.
An extension cord must have adequate wire size (AWG 
or American wire Gauge) for safety. The smaller the gauge 
number of the wire, the greater the capacity of the cable, that is 16 
gauge has more capacity than 18 gauge. When using more than 
one extension to make up the total length, be sure each individual 
extension contains at least the minimum wire size.  
minimum Gauge for Cord sets
 volts 
total Length of Cord in Feet
120V
0-25  26-50  51-100  101-150
240V
0-50  51-100  101-200  201-300
 Ampere Rating 
 More Not more
American Wire Gauge
Than Than
0  -  6
18
16
16
14
6  -  10
18
16
14
12
10  -  12
16
16
14
12
12  -  16
14
12
Not Recommended