Black & Decker LSWV36 User Manual

VacUUM OperaTION

NOTe: Ensure the sweeper is switched off and the battery is removed

from tool before attaching or removing the vacuum tubes. The vacuum

tube and collection bag must be assembled to the housing before use.

Install battery after assembly just prior to use.

• Attach the collection bag to the power head as shown in figure E.

• Remove the fan cover from the side of the sweeper housing by

pressing the spring loaded release button (located on the lower right

side of the sweeper housing) and pulling the cover off (figure g).

• Attach the vacuum tube assembly to the fan inlet on the sweeper

housing (figure H) by lining up the tabs on the tube with the slots

on the sweeper housing and push inwards until the locking/release

button is fully engaged. (figure H1)

• Position the tube slightly above the debris/leaves. Turn the unit on,

then using a side to side sweeping motion the debris/leaves will be

sucked up the tube, mulched and deposited into the collection bag

(figure L)

As the bag fills the power of the suction will decrease. To empty

collection bag, switch off your product and remove the battery from

the tool. Remove the collection bag from the power head, unzip the

collection bag to empty. Re-assemble

before continuing to operate.

when used properly on the correct

applications, this unit should not jam. This

tool is not intended to vacuum wet leaves

or debris and is designed primarily for

clean up of hard surfaces like decks, patios

or garages. The tool should not be used to

vacuum litter or non-organic debris.

wHaT TO dO If THe UNIT jaMS: (FigURE M)

CAUtiOn: tURn OFF Unit AnD REMOVE BAttERY FROM tOOL.

If the unit motor stops, the fan has become jammed. If this

happens,turn the unit off then remove the battery. Remove the bag

and vacuum tube. Remove the jamming material using a small

wooden stick. Do not use a metal implement or anything, which

may damage the fan or scratch the plastic. Ensure the fan will turn

by hand before reassembling the unit.

If the unit stops picking up debris or the performance substantially

reduces it may have become clogged. Switch the unit off then

remove the battery. Remove the vacuum tube and look down the

tube to ensure no debris is blocking it. If necessary remove debris

with a small wooden stick. Do not use a metal implement or

anything, which may scratch or

damage the tube. Remove the bag.

If the bag is full, empty the bag. If

necessary remove any debris

from around the fan or unit outlet

using a small wooden stick.

Do not use a metal implement or

anything which may damage the

fan or scratch the plastic. Ensure the

fan will turn by hand before

reassembling the unit

acTIONS THaT May Lead TO THe UNIT jaMMING are:

• Vacuuming wet leaves or wet debris.

• Vacuuming litter or non-organic debris.

• Vacuuming debris with an already filled bag.

• Vacuuming large twigs or sticks.

• Submerging the tip of the vacuum tube into a pile of leaves or debris.