Toro 11185SL User Manual
Reelmaster 7000
Hydraulic System
Page 4 -- 94
Cutting Reel Motor Service
1. Dust seal
2. Retaining ring
3. Flange washer
4. Shaft seal
5. Front flange
6. Pressure seal
7. Back--up gasket
8. Front wear plate
9. Dowel pin
10. Idler gear
11. Drive shaft
12. Rear wear plate
13. O--ring
14. Relief valve
15. Body
16. Washer (4 used)
17. Lock washer (4 used)
18. Cap screw (4 used)
2
3
6
9
9
10
11
13
1
5
7
12
14
15
16
17
18
4
6
7
8
14
33 ft--lb
(45 N--m)
19 ft--lb
(25 N--m)
19 ft--lb
(25 N--m)
Figure 68
Disassembly (Fig. 68)
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker to make a diagonal line across the
front flange and body for assembly purposes (Fig. 69).
IMPORTANT: Prevent damage when clamping the
reel motor into a vise; clamp on the front flange only.
Also, use a vise with soft jaws.
3. Clamp front flange of motor in a vise with soft jaws
with the shaft end down.
MARKER LINE
Figure 69