Yazoo/Kees ZMKW52212 User Manual

English

-

45

LUBRICATION

If possible, grease both ends of the cables and move 

the controls to end stop positions when lubricating. 

Refit the rubber covers on the cables after lubrication. 

Cables with sheaths will bind if they are not lubricated 

regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it 

vertically. Lubricate it with light engine oil until the oil 

begins to escape from the bottom. 

Tip:  

Fill a small plastic bag with oil and tape 

it so that it seals against the sheath 

and allow the cable to hang vertically 

from the bag overnight. If you do not 

succeed  in  lubricating  the  cable,  it 

must be replaced.

Lubricate the cable ends by the carburetor with an oil 

can. Move the controls to the end points and lubricate 

again. 
The throttle cable is also lubricated by the control when 

the control console is removed.
The illustration shows the Kawasaki engine.

Lubricate the bearings of the shafts and linkage for the 

brake system and steering with oil spray or oil can.

Lubricate with a grease gun, one zerk for each wheel 

mount, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical 

companies, etc.) usually maintains a good quality.

Lubricate with a grease gun, one zerk for each set of 

wheel bearings, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical 

companies, etc.) usually maintains a good quality.

8011-605

8011-573