Alamo 00759354C User Manual

SAFETY

A60B/A72B 02/07

Safety Section 1-13

SAFETY

Maintenance and Service Safety Instructions and Practices

Make sure the PTO shield, integral driveline shields, and input shields are

is installed when using PTO-driven equipment. Always replace any

shield if it is damaged or missing.

(S3PT-8)

Relieve hydraulic pressure prior to doing any maintenance or repair work

on the Implement. Place the Implement on the ground or securely

blocked up, disengage the PTO, and turn off the tractor engine. Push and pull the Remote

Cylinder lever in and out several times prior to starting any maintenance or

repair work.

(S3PT-9)

Always disconnect the main PTO Driveline from the Tractor before performing service on

the Implement. Never work on the Implement with the tractor PTO driveline connected and

running. Rotating Parts, Blades or Drivelines could turn without warning and cause immediate entanglement,

injury or death.

(S3PT-11)

Never interfere with factory-set hydraulic calibrations. Any change in calibration could

cause a failure of the equipment and may result in injury.

(SBH-13)

Always maintain the safety signs in good readable condition. If the safety signs are

missing, damaged, or unreadable, obtain and install replacement safety signs immediately.

(SG-5)

Do not modify or alter this Implement. Do not permit anyone to modify or alter this

Implement, any of its components or any Implement function.

(SG-8)

Never work under the Implement, the framework, or any lifted

component unless the Implement is securely supported or blocked up

to prevent sudden or inadvertent falling which could cause serious

injury or even death.

(SG-14)

Never attempt to lubricate, adjust, or remove material from the Implement while it is in

motion or while tractor engine is running. Make sure the tractor engine is off, the

transmission in park, the parking brake set, and that the key is with you before working on

the implement.

(SG-20)