Alamo 00759354C User Manual
ASSEMBLY
A60B/A72B 02/07
Assembly Section 3-4
©2007 Alamo Group Inc.
ASSEMBL
Y
Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will
provide protection from thrown objects with proper operation under normal conditions. Deflectors must be
maintained in good repair or replaced after no more than two inches of wear off lower edge.
Front Rubber Fabric Deflectors (Standard Equipment)
Front Deflector (Figure Asm-R-0085)
1.
Attach the Front Bracket (1) to the front of the
mower with 5/8" x 3" Bolts (3), Flatwashers (9)
and Locknuts (4).
mower with 5/8" x 3" Bolts (3), Flatwashers (9)
and Locknuts (4).
2.
Attach the Front Deflector (2) to the Bracket
with 3/8" x 1-1/2" Bolts (5), Woodwashers (8),
Flatwashers (6), and Locknuts (7), as shown in
Figure Asm-R-0085.
with 3/8" x 1-1/2" Bolts (5), Woodwashers (8),
Flatwashers (6), and Locknuts (7), as shown in
Figure Asm-R-0085.
Rear Rubber Fabric Deflectors (Standard Equipment)
Rear Deflector (Figure Asm-R-0086)
1.
Attach the Right and Left Deflector Weldment (1
& 2) to the mower deck using 1/2" x 1-1/4" bolts
(5) and locknuts. Attach the Right and Left
Deflector Weldments (1 & 2) together using 1/2"
x 4" bolts (6), flatwasher (7) and locknuts.
& 2) to the mower deck using 1/2" x 1-1/4" bolts
(5) and locknuts. Attach the Right and Left
Deflector Weldments (1 & 2) together using 1/2"
x 4" bolts (6), flatwasher (7) and locknuts.
2.
Attach the Right and Left Mount Plates (9 & 10)
to the mower deck and the Deflector
Weldments using 1/2" x 1-1/4" bolts, flatwasher
and locknuts.
to the mower deck and the Deflector
Weldments using 1/2" x 1-1/4" bolts, flatwasher
and locknuts.
3.
Attach the Deflector Panels (3) to the Deflector
Weldments using Deflector Bar (4), 1/2 x 1-1/4"
bolts, and locknuts.
Weldments using Deflector Bar (4), 1/2 x 1-1/4"
bolts, and locknuts.