HGST Travelstar 7K500 BE, 320GB 0A79103 User Manual
Product codes
0A79103
7K500 OEM Specification
Page 88 of 176
14.8
14.8
14.8
14.8 Format Unit (F7h: V
Format Unit (F7h: V
Format Unit (F7h: V
Format Unit (F7h: Vendor Specific)
endor Specific)
endor Specific)
endor Specific)
Command Block Output Registers
Command Block Input Registers
Register
7 6 5 4 3 2 1 0 Register
7 6 5 4 3 2 1 0
Data
- - - - - - - - Data
- - - - - - - -
Feature
V V V V V V V V Error
...See Below...
Sector Count
- - - - - - - - Sector Count
- - - - - - - -
LBA Low
- - - - - - - - LBA Low
- - - - - - - -
LBA Mid
- - - - - - - - LBA Mid
- - - - - - - -
LBA High
- - - - - - - - LBA High
- - - - - - - -
Device
- - - - - - - - Device
- - - - - - - -
Command
1 1 1 1 0 1 1 1 Status
...See Below...
Error Register
Status Register
7
8
9
10
3
2
1
0
7
6
5
4
3
2
1
0
CRC UNC
0
IDN
0
ABT T0N AM
N
BSY RDY
DF
DSC DRQ COR IDX ERR
0
0
0
V
0
V
0
0
0
V
0
V
-
0
0
V
Table 53 Format Unit Command (F7h)
The Format Unit command initializes all user data sectors after merging reassigned sector location
into the defect information of the device and clearing the reassign information. Both new reassign
information and new defect information are available right after this command completion, and are
also used on next power on reset. Both previous information are erased from the device by this
command.
into the defect information of the device and clearing the reassign information. Both new reassign
information and new defect information are available right after this command completion, and are
also used on next power on reset. Both previous information are erased from the device by this
command.
Note that the Format Unit command initializes from LBA 0 to Native MAX LBA. Host MAX LBA set
by Initialize Drive Parameter or Set MAX ADDRESS command is ignored. So the protected area by
Set MAX ADDRESS commands is also initialized.
by Initialize Drive Parameter or Set MAX ADDRESS command is ignored. So the protected area by
Set MAX ADDRESS commands is also initialized.
The security erase prepare command should be completed immediately prior to the Format Unit
command. If the device receives a Format Unit command without a prior Security Erase Prepare
command the device aborts the Format Unit command.
command. If the device receives a Format Unit command without a prior Security Erase Prepare
command the device aborts the Format Unit command.
If Feature register is NOT 11h, the device returns Abort error to the host.
This command does not request to data transfer.
Output Parameters To The Device
Feature
Feature
Destination code for this command
11H Merge reassigned location into the defect information
The execution time of this command is shown below.
HTS725050A9A3XX
128 min
HTS725040A9A3XX
106 min
HTS725032A9A3XX
83 min
HTS725025A9A3XX
65 min
HTS725016A9A3XX
50 min
HTS725012A9A3XX
31 min