Kenmore 486.24227 User Manual
9
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
DO NOT RETURN TO STORE
CANOPY INSTALLATION
FIGURE 12
5/16" x 2"
CARRIAGE BOLT
CARRIAGE BOLT
5/16" FLAT
WASHER
WASHER
PLASTIC
KNOB
KNOB
UPRIGHT
TUBES
TUBES
STEP 1:
(Figure 12)
Assemble the upright tubes to the base assembly.
NOTE: If holes are difficult to align, loosen bolts attaching
base tubes to mounting bracket(s). If hole alignment is
still difficult, loosen bolts attaching mounting bracket to
rear fender. Retighten all bolts when finished.
base tubes to mounting bracket(s). If hole alignment is
still difficult, loosen bolts attaching mounting bracket to
rear fender. Retighten all bolts when finished.
STEP 2:
(Figure 13)
Assemble the top tubes to the upright tubes.
Do not
tighten yet.
STEP 3:
(Figure 13)
Fit the front U-tube onto the top tubes. Fasten the tubes
together.
together.
Tighten all loose bolts and nuts.
STEP 4:
(Figure 13)
Fit the three support rods into the holes in the top tubes,
with the rods arching upward.
with the rods arching upward.
Do not over-bend the rods
when installing.
1/4" NYLOCK
NUT
NUT
U-TUBE
1/4" x 1-1/2"
HEX BOLT
HEX BOLT
SUPPORT ROD
1/4" x 1-1/2"
HEX BOLT
HEX BOLT
1/4" NYLOCK
NUT
NUT
TOP TUBES
FIGURE 13
STEP 5:
(Figure 14)
Place the vinyl canopy on top of the tubing frame, fitting
the front of the vinyl canopy around the front U-tube.
Secure the nylon mesh to the upright tubes using the ties
located on the corners of the mesh.
the front of the vinyl canopy around the front U-tube.
Secure the nylon mesh to the upright tubes using the ties
located on the corners of the mesh.
FIGURE 14
CAUTION: Make sure tractor seat raises
and lowers freely after attaching Sun
Shade. The tractor's operator presence
safety switch will not operate if seat is
stuck down.
and lowers freely after attaching Sun
Shade. The tractor's operator presence
safety switch will not operate if seat is
stuck down.