Manualsbrain.com
  1. Manuals
  2. Brands
  3. HTC
  4. LZC6130 / 965879801
  5. User Manual

HTC LZC6130 / 965879801 User Manual

Download
Page of 76
MAINTENANCE
38
 - Husqvarna
1
2
8011-466
1. Terminal guard
2. Battery hold downs
Battery installation
Battery
Your mower is equipped with a maintenance free 
battery and does not need servicing. However, 
periodic charging of the battery with an automotive 
type battery charger will extend its life.
• 
Keep battery and terminals clean.
• 
Keep battery bolts tight.
• 
See charge for charging times.
IMPORTANT INFORMATION
Do not attempt to open or remove caps or 
covers. Adding or checking level of electrolyte 
is not necessary.
Always use two wrenches for the terminal 
screws.
WARNING!
Always wear eye protection when 
around batteries.
WARNING!
Do not short battery terminals by 
allowing a wrench or any other 
object to contact both terminals at 
the same time. Before connecting 
battery, remove metal bracelets, 
wristwatch bands, rings, etc.
Positive terminal must be connected 
first to prevent sparks from 
accidental grounding.
STANDARD 
BATTERY
STATE
OF 
CHARGE
APPROXIMATE BATTERY CHARGING TIME* 
TO FULL CHARGE AT 80
O
F / 27
O
C
Maximum Rate at:
50 Amps
30 Amps
20 Amps
10 Amps
12.6V
100%
 - FULL CHARGE -
12.4V
75%
20 min.
35 min.
48 min.
90 min.
12.2V
50%
45 min.
75 min.
95 min.
180 min.
12.0V
25%
65 min.
115 min.
145 min.
280 min.
11.8V
0%
85 min.
150 min.
195 min.
370 min.
*Charging time depends on battery capacity,  
condition, age, temperature and efficiency of charger
Cleaning battery and terminals
Corrosion and dirt on the battery and terminals can 
cause the battery to “leak” power.
Lift the seat and rotate forward.
1. 
Remove the red terminal guard
2. 
Disconnect BLACK battery cable first, then 
3. 
the RED battery cable and remove the battery 
from the machine.
Rinse the battery with plain water and dry.
4. 
Clean terminals and battery cable ends with 
5. 
wire brush until shiny.
Coat terminals with grease or petroleum jelly.
6. 
Reinstall battery.
7. 
Replacing battery
Lift seat and rotate forward.
1. 
Remove the red terminal guard.
2. 
Using two ½" wrenches disconnect BLACK 
3. 
battery cable then RED battery cable.
Remove knobs and battery hold downs.
4. 
Carefully remove the battery from the mower.
5. 
Install new battery with terminals in the same 
6. 
position as the old battery.
Reinstall the battery hold downs.
7. 
First connect RED battery cable to positive (+) 
8. 
battery terminal with hex bolt and hex nut.
Connect BLACK grounding cable to negative 
9. 
(-) battery terminal with remaining hex bolt and 
hex nut.
Tighten securely.
10. 
Replace the red terminal guard
11. 
Lower seat.
12.