HTC LZC6130 / 965879801 User Manual

MAINTENANCE

Husqvarna 

- 

45

Check belt every 100 hours for excessive wear.
To replace belt. Relieve tension on the deck belt and 

remove deck belt from clutch. See “Deck belt” section. 

Loosen bolt on the clutch tie down and rotate out of 

the way.
Using a ½" drive ratchet inserted into the square hole 

in the pump idler arm, relieve the tension on the pump 

belt and remove belt.
To reinstall the belt, swing pump idler pulley toward 

engine to route belt around it. Then route belt around 

the pulley for left pump first (right hand pulley in the 

illustration).
Reinstall idler spring and use the ratchet to rotate idler 

so the belt may be installed all the way around the last 

pulley.

8011-623

8011-624

All four tires should have a pressure of 15 psi / 103 

kPa /1 bar.

8011-511-1

Visually check that no damage is found on the lever, 

links, or switch belonging to the parking brake. 

Perform a test drive and check that there is sufficient 

braking action.
To adjust the parking brake, contact the Husqvarna 

service workshop.